Publicidad
1
q
w
q
w
q
r
w
e
1
q
2
w
4
2
e
2
3
5
20
Winding the Bobbin
Removing the bobbin
1 Slide the hook cover plate release button to the
right, and remove the hook cover plate.
q Hook cover plate release button
w Hook cover plate
2 Lift out the bobbin from the bobbin holder.
e Bobbin
Setting the spool of thread
Lift up the spool pin. Place the spool of thread on the
spool pin with the thread coming off the spool as
shown.
q Large spool holder
Attach the large spool holder, and press it firmly
against the spool of thread.
Use the small spool holder to hold narrow or small
spools of thread.
w Small spool holder
Additional spool pin
Use the additional spool pin when you need to wind
the bobbin without unthreading the machine while
working on a sewing project.
Insert the additional spool pin into the spool stand
and then into the hole in the machine.
Place the felt on the spool pin and place a spool of
thread on it as shown.
q Additional spool pin
w Felt
e Hole
r Spool stand
Threading for bobbin winding
1 Set the speed control slider at
Guide the thread around the thread guide.
q Thread guide
2 Pass the thread through the hole in the bobbin
from the inside to the outside. Put the bobbin on
the bobbin winder spindle.
w Bobbin winder spindle
3 Push the bobbin winder spindle to the right.
The indicator will show
4 Hold the free end of the thread in your hand and
depress the foot control.
Stop the machine after the bobbin has spun
several times, and cut the thread close to the hole
in the bobbin.
5 Depress the foot control again. When the bobbin
is fully wound, it will stop automatically.
Release the foot control and return the bobbin
winder spindle to its original position by moving it
to the left, and cut the thread with a pair of
scissors. Remove the bobbin from the bobbin
winder spindle.
NOTE:
The machine will not sew until the spindle has been
returned to the left.
.
.
Publicidad
