Publicidad
Step 6
Separate the EXTENSION SLIDES (TT) from the
å
EXTENSION RAILS (SS) as shown in the upper diagram
below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (SS) to the RIGHT END (A)
å
and RIGHT UPRIGHT (E). Use four GOLD 5/16" FLAT
HEAD SCREWS (RRR).
NOTE: For each EXTENSION RAIL, turn a SCREW into the
å
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to fi nd the other hole
that lines up with the hole in the END and UPRIGHT. Turn
a SCREW into this hole.
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
Open end
Finished edge
www.sauder.com/services
TT
Push the black lever in and pull the SLIDE from the RAIL.
RRR
SS
E
SS
401634
Open end
Finished edge
SS
A
Page 11
Publicidad
