Publicidad
Step 9
Fasten the LEFT HUTCH END (D3) to the LEFT
å
MOLDING (GG) on the HUTCH TOP (I). Tighten two
TWIST-LOCK® FASTENERS.
Insert eight METAL PINS (GGG) into the SMALL
å
PINNED UPRIGHTS (R).
Insert the METAL PINS (GGG) in one end of the
å
SMALL PINNED UPRIGHTS (R) into the holes in the
HUTCH TOP (I).
II
D3
i t h
e w
K ®
f a c
L O C
S u r
I S T -
E R S
T W
T E N
F A S
Page 14
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the hole of the
adjoining part.
NOTE: The dowel end of the FASTENER must remain fully
inserted in the hole of the adjoining part while locking
the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as tight
as possible.
Finished edge
GG
R
R
(8 used)
401634
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
®
I
GGG
FASTENER
Dowel end
EE
www.sauder.com/services
Publicidad
