Publicidad
Step 3
Fasten the ANGLE BRACKET (DDD) to the LEFT END (B)
å
and DESK END MOLDING (HH). Use two BLACK 9/16"
LARGE HEAD SCREWS (PPP).
NOTE: There is no pre-drilled hole in the END MOLDING.
å
The SCREW will tighten into the groove.
Fasten the RAIL BRACKETS (ZZ) to the LEFT END (B).
å
Use four BLACK 9/16" LARGE HEAD SCREWS (PPP).
BLACK 9/16" LARGE HEAD SCREW
(6 used in this step)
Page 8
DDD
PPP
Groove
HH
B
401634
Remember:
Righty tighty.
Lefty loosey.
ZZ
www.sauder.com/services
Publicidad
