Dreame DreameBot D9 Plus Manual Del Usuario página 7

Preparation Before Use
EN
1. Remove the protective strips
2. Install the side brush
Click
Note: Install the side brush until it clicks into place.
8
3. Connect to a power outlet and start charging
Place the base on level ground against the wall and connect it to a power
outlet. Place the robot onto the base to charge. The robot will turn on
automatically and begin charging. It is recommended to fully charge your
robot before first-time use.
> 0.3 m
Within the Good
Wi-Fi Range
> 0.5 m
> 0.5 m
Put away the power cord
into the cord storage slot
> 1.5 m
Note:
• Keep the immediate area 1.5 m in front of the base and 0.5 m to its both sides
clear of objects.
• Make sure that no objects might block the signaling area.
About the Auto-Empty Base
It is recommended that the robot set out from the base before cleaning. Do not
move the base while the robot is cleaning. This ensures that the robot returns to
base smoothly.
After the robot completes the cleaning task and automatically returns to the
base, the base will start auto-empty. More settings can be operated on the APP.
Connecting with Dreamehome App
This product works with the Dreamehome App which can be used to
control your device.
Scan the QR code on the robot, or search for "Dreamehome" in the app store to
download and install the app.
QR Code
2. Add Device
Open the Dreamehome App, tap " " in the upper right corner, and scan the
QR code above again to add "DreameBot D9 Plus". Please follow the prompts
to finish the Wi-Fi connection.
Wi-Fi Indicator
· Blinking slowly: To be
connected
· Blinking quickly: Connecting
· On: Connected
Note:
• Only 2.4GHz Wi-Fi is supported.
• Due to upgrades in the app software, the actual operations may differ
from the directions in this manual. Please follow the instructions based on
the current app version.
3. Reset Wi-Fi
Simultaneously press and hold the and buttons until you hear a
voice prompt say, "Waiting for the network configuration." Once the Wi-Fi
indicator is blinking slowly, the Wi-Fi has been successfully reset.
Note: If your robot cannot connect to the app successfully, reset the Wi-Fi and
add the device again.
EN
9