Publicidad
Idiomas disponibles
Idiomas disponibles
GB
6.1
Putting on the double carrying belt (10)
Follow figure (10) to put on the double carrying
belt.
■
Always use a carrying belt during work.
■
Only attach the appliance after the engine
has been started and is running in idle.
6.2
Starting/stopping the engine
6.2.1
Information on engine operation
Before starting
■
Place the brushcutter level and free of obsta-
cles on the ground. The cutting tool must not
be touching any objects or the ground.
When starting
■
Do not stand on the shaft to avoid damage to
the shaft and/or the angle-drive gearbox in-
side the shaft.
■
Make sure you are standing securely and
hold the brushcutter firmly at the housing
flange.
Positions of the choke lever
CHOKE
Cold start (choke lever in CHOKE position)
If the engine is cold, i.e. if it has not been in use
for more than 5 minutes, a "cold start" is carried
out.
Warm start (choke lever in RUN position)
If the engine is still warm from use, i.e. shortly af-
ter it was switched off, a "warm start" is carried
out. The choke is not used in this case.
6.2.2
Carry out a cold start/warm start (11,
12)
NOTE With the "Ready to Start" function,
the ON/OFF switch is always in the ON posi-
tion. Push the ON/OFF switch to the OFF posi-
tion to stop the appliance. When the switch is
pressed, it returns automatically to the ON posi-
tion.
NOTE Automatic resetting of the choke
lever. In the event of an immediate start of the
engine, the choke lever returns automatically to
the RUN position when the throttle lever is
pressed.
32
Cold start
1. Move choke lever (11/1) to CHOKE position
2. Briefly and firmly press primer button (11/2)
3. Starting the engine:
4. Allow the engine to warm up for a few min-
5. Move the choke lever to RUN position (11/b).
Hot start
If the engine is still warm from use, i.e. shortly af-
ter it was switched off, a "warm start" is carried
out. The choke is not used in this case.
1. (Optional) Move choke lever (11/1) to the
RUN
The engine is running
The engine runs at idle speed.
Note: Press throttle lever (12/1) if the engine no
longer runs smoothly. The engine speed can be
fixed with locking button (12/3).
Stopping the engine
1. Release the throttle lever (12/1) and let the
2. Move ON/OFF switch (12/2) to the STOP po-
(11/a).
approx. 7 to 10 times.
■
Press the appliance firmly onto the
ground with one hand.
■
With the other hand, pull the starter han-
dle (11/3), first carefully and slowly until
resistance is felt, and then firmly and
quickly upwards until resistance is felt
again (approx. 1 arm length).
■
Allow the starter rope to coil up again, but
without releasing the starter handle.
■
Repeat the previous steps several times
until the engine starts.
utes.
CHOKE position and then immediately back
to the RUN position. Automatic half throttle is
now set.
■
Press the appliance firmly onto the
ground with one hand.
■
With the other hand, pull the starter han-
dle (11/3), first carefully and slowly until
resistance is felt, and then firmly and
quickly upwards until resistance is felt
again (approx. 1 arm length).
■
Allow the starter rope to coil up again, but
without releasing the starter handle.
■
Repeat the previous steps several times
until the engine starts and runs smoothly.
engine run at idling speed.
sition and hold there for a few seconds.
Operation
443443_a
Publicidad
