Descargar Imprimir esta página

Vortice LINEO 125 ES Manual De Instrucciones página 9

Ocultar thumbs Ver también para LINEO 125 ES:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
A multi-pole switch must be
used to install the appliance.
The contact opening gap must
be no less than 3 mm.
Typical application
Fig. 1-2;
If the appliance is installed at a height of less than 2.3
metres from ground level and the length of the ducting
connected to the inlet and outlet so requires, special
safety devices should be fitted to prevent any risk of
contact with the blades.
Installation
Fig. 3 ÷ 26;
Fig.3: E= Air flow direction data plate; C= Air Inlet; D=
Air Outlet.
Initial configuration
The installer must configure appliance operation by
following the steps described later on.
selecting the product model: see below. This step is
carried out in the factory; the instructions provided in
this booklet may only be of use if it becomes
necessary to reset the status following accidental
tampering with the dip-switch.
selecting the operating mode: see below. There are
two modes: with two speeds V1 and V2, which can be
selected via an external switch, or with speed that can
be adjusted via an external potentiometer.
setting the V1 and V2 values (for two-speed operating
mode)
Selecting the product model
The model is selected by setting the dip-switch 1
indicated in the figure as described in the table below.
DIPSWITCH
SW 1 : MODEL
SW 2 : SETUP
2
1
TRIMMER
LINEO 100 Q ES - LINEO 200 ES
DIPSWITCH
SW 1 : MODEL
SW 2 : SETUP
2
1
TRIMMER
LINEO 250 ES, LINEO 315 ES
Model
LINEO 100 Q ES
LINEO 100 ES
LINEO 125 ES
LINEO 150 ES
LINEO 160 ES
LINEO 200 ES
LINEO 250 ES
LINEO 315 ES
ENGLISH
ON
OFF
1 2 3 4
ON
OFF
1 2 3 4
SW1
Int.1 Int.2 Int.3 Int.4
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
OFF
OFF
ON
OFF
ON
OFF
OFF
ON
OFF
OFF
ON
ON
OFF
ON
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
9

Publicidad

loading