Daikin FWI-AT Serie Manual Del Usuario página 34

direction of fl ow and that it does not form a siphon (FIGURE
1).
Ū The piping must have several supports (FIGURE 2).
Ū Do not install an air vent (FIGURE 3) in the wrong position.
» Fig�1
» Fig�2
» Fig�3
DIMENSIONAL UNIT ASSEMBLY
Ū Use the dimensional drawings to determine the position of
the suspension rods (Fig.4 FWI-A 02-03-04) (Fig.5 FWI-A 06-
07-08)
Ū Position the suspension rods (not supplied) in place.
Ū Attach the supplied brackets (Fig.6 ) to the suspension rods
(Fig.7 ). The length of the suspension rods depends on the
space between the suspended ceiling and the structural
ceiling.
Ū The distance C (Fig.7 ) must be:
Model
FWI-A 02-03-04
FWI-A 06-07-08
Ū Pay attention to the excess length B of the suspension rod
(Fig.7 ): it may interfere with the unit's electrical box.
Ū Place the fan coil unit in the suspended ceiling, orienting
the side with the water connections in the most appropriate
28
FWI-AT/AF
C- Bracket distance to the false
ceiling
270
312
position, using the hooks on the brackets to provide quick
temporary installation.
Ū Then attach the unit to the threaded bars with the screws
provided and check that it is level (Fig.8 )
Ū Adjust the distance between the unit and suspended ceiling
D (Fig.9 FWI-A 02-03-04 and Fig.10 FWI-A 06-07-08) using
the nuts of the suspension rods:
Model
FWI-A 02-03-04
FWI-A 06-07-08
Ū Make sure that the unit does not touch the ceiling: contact
may cause noise.
Ū Insulate the brackets (Fig.6 ) fi xed on the unit with the insu-
lation supplied.
» Fig�4 FWI-A 02-03-04
» Fig�5 FWI-A 06-07-08
» Fig�6
D - Distance from unit to false
ceiling
23
48
11