Publicidad
Idiomas disponibles
Idiomas disponibles
Operator troubleshooting
Most minor problems can be resolved quickly and easily using the table below.
If problems persist, contact a metabo HPT authorized service center for assistance.
PROBLEM
Nailer operates, but no nail is
driven.
Weak drive.
Slow to cycle.
Drives too deep.
Skipping nails.
Intermittent feed.
Nails jam.
Driven nail is bent.
Drives properly during normal
operation, but does not drive
fully at faster nailing speeds.
CHECK METHOD
Check for a jam.
Nail feeder damaged?
Ribbon spring weakend or
damaged?
Check for proper nails.
Check air pressure.
Check position of nailing
depth adjustment adjuster.
———
Driver blade worn?
Piston O-ring worm or
damaged?
Check air pressure.
Check position of nailing
depth adjustment guide plate
(A).
Check for proper nails.
———
Nail feeder damaged?
Ribbon spring weakend or
damaged?
Piston O-ring worn or
damaged?
Check for proper nails.
———
Driver blade worn?
Check inside diameter of air
hose.
CORRECTION
Clear a jam page 20.
Replace nail feeder.
Replace ribbon spring.
Use only recommended nails.
Increase air pressure.
(Do not exceed 120 psi (8.3
bar 8.5 kgf/cm
))
2
Readjust per page 18.
Use metabo HPT pneumatic
tool lubricant.
Contact metabo HPT for
replacement.
Reduce air pressure.
(Adjust 70 – 120 psi
(4.9 – 8.3 bar 5 – 8.5 kgf/cm
Readjust per page 18.
Use only recommended nails.
Lubricate the nail rail per
page 20.
Replace nail feeder.
Replace ribbon spring.
Contact metabo HPT for
replacement.
Use only recommended nails.
Lubricate the nail rail per
page 20.
Contact metabo HPT for
replacement.
Use larger air hose.
English
))
2
23
Publicidad
