Tristar KZ-1228 Manual De Usuario página 9

3. Insert a new water filter and then close the water filter bracket again.
4. Place the water filter bracket back into the water reservoir. Make sure
that the water filter is seated correctly in the slot in the water reservoir.
5. To delete the symbol on the display, press the coffee Strength
button and the 2–12 Cups button simultaneously.
Tip: The absence of a water filter does not stop the device from working
properly.
caRe aND DeScalINg
PleaSe NoTe!
• The hotplate is very hot after use! Let it cool down first before cleaning it.
• Never immerse the device, the cable or the plug in water.
• Do not use corrosive or abrasive cleaning agents to clean the device.
These could damage the surface.
1. Clean the coffee mill using the cleaning brush.
2. Adjust the screw at the opening for cleaning the coffee mill with the shaft
end of the cleaning brush to the "Open" symbol
and you can then remove any excess coffee powder with the cleaning brush.
3. Then close the cover again by pressing down on the cover and
adjusting the screw on the opening for cleaning the coffee mill with
the shaft end of the cleaning brush to the "Closed" symbol
4. Then press the unlocking button on the side of the device and open
the filter compartment.
5. Remove the filter cover, take out the permanent filter and dispose of
the coffee powder.
6. Clean the filter cover, the permanent filter and the filter compartment
insert with hot water and a little detergent if necessary.
7. Then dry all parts thoroughly and place them in the coffee machine again.
8. If necessary, clean the coffee machine and hotplate with a damp cloth
and then with a dry one.
DeScalINg
If the water only runs very slowly through the device or the device is
louder than usual during the brewing procedure, you should descale it.
1. Pour the mixture consisting of water and descaling agent into the water
reservoir and switch on the device. Pay attention to the directions for use
of the descaling agent in regard to the ratio of water to descaling agent.
2. Let the mixture run through the machine completely. Repeat this
procedure if the water still runs through slowly.
3. After descaling, let water (without coffee) run through the device at
least three times to flush the lines etc.
4. Please ensure that you have switched on the grind off function if you
want to flush the device with water or descale it.
TRouBleSHooTINg
If the device should stop working properly, check whether you are able to
correct the problem yourself. Do not try to repair a faulty device yourself!
. The cover will open up
Problem
The device
does not work
.
appears on the
display.
Possible cause/solution
• Is the plug inserted in the mains socket correctly?
• Is the mains socket defective? Try another mains socket.
• Check the fuse of the main connection.
• Is the coffee filter correctly inserted?
• Is the filter placed correctly?
• Is the glass pot sitting correctly on the hotplate?
Pull the plug out of the socket to reset all of the settings
you have made. Check whether the filter compartment
insert, the permanent filter are positioned correctly,
whether the cover for cleaning the coffee mill is closed
correctly and then try to start the brewing procedure
again.
Coffee maker
eN
9