Tabla de contenido
Publicidad
1
1. DC INPUT
Port to connect main power. Use the included
dbdrums PSU. 9V DC 2A.
2. TRIG 1/2
Used for connecting a single or dual zone trigger
pad or an acoustic drum trigger. A stereo connecting
cable is needed for full dual zone functionality. When
a signal has been received the left-most trigger lights
will illuminate when hit.
TRIGGER
FOOTSWITCH
3. TRIG 3/4
Used for connecting a dual zone trigger pad or an
acoustic drum trigger. A stereo connecting cable is
needed for full dual zone functionality. When a signal
has been received, the right-most trigger lights will
illuminate when hit.
TRIGGER
FOOTSWITCH
4. FS1
Used for connecting a footswitch trigger. By default,
it assumes this will be a hi-hat pedal. The left
footswitch light will illuminate when played.
TRIGGER
FOOTSWITCH
5. FS2
Used for connecting a second footswitch trigger. By
default, it assumes this will be a kick drum sound.
The right footswitch light will illuminate when played.
TRIGGER
FOOTSWITCH
6. USB - B
USB-B connecting port, used for connecting the
nPad to a computer through USB MIDI cable.
User Manual
REAR PANEL
3
2
5
4
6
7
8
9
10
11
7. USB - A
USB-A connection, used to connect memory stick
for updates as well as importing and exporting your
own sound files and kits. This can be done using
nPad Wave Manager importing software.
More information on using a USB memory stick with
the nPad, see page 7.
8. MIDI IN/OUT
Used for connecting 5-pin MIDI cable to send
information either from or to the nPad.
9. AUX
Used for connecting an auxiliary sound source to
the nPad via a 1/8" Stereo Jack cable (available
separately), ideal for connecting an MP3 player,
smartphone, tablet or laptop. Volume must be
controlled via the sound source.
10. MAIN OUT L/R
Main output jacks of the nPad. Connect via 1/4" mono
jack cables to your mixer, interface or amplifier. When
using one jack cable (for mono output), insert your
jack cable into L/ MONO output. Connecting two jack
cables sends separate left and right audio signals
down each cable, giving you stereo output.
11. MASTER VOLUME
Controls the main output volume for the nPad.
12. HEADPHONES
1/4" output jack for connecting headphones, control
output level with VOLUME KNOB on the front panel.
WARNING!
To prevent damage to your hearing, speakers and
other audio equipment, reduce the volume and
have the power off before connecting to any other
equipment. Please make sure you are using the
headphone output for headphones and the main
output when connecting to amplifiers or mixers.
12
5
Publicidad
Tabla de contenido
