DBDrums Multi Sample Pad Manual Del Usuario página 27

WAVE
Gives you the ability to adjust individual samples
within a preset. Hit a PAD to select it and begin
editing. Press SELECT to scroll through the different
submenus and press OK to save.
A B
C
D
E
F
A.
Shows which pad is being edited.
B.
Shows which sound group the pad is linked to.
C.
SAMPLE A - If you are just using one sound on the
pad, SAMPLE A will be the only sample. Whilst the
sample is highlighted you can use the SCROLL
WHEEL or +/- buttons to change this to a different
sound, if you want to confirm the change, press the
OK button.
D.
SAMPLE B - This feature can be used if two samples
are triggered by the same pad. Sounds are triggered
by different velocities. For example: soft hit = closed
hi-hat, hard hit = open hi-hat. Velocity adjustment can
be changed in the ADV menu. More information is
available on page 10.
E.
Vol A / B - This is used to control the output volumes
of sample A and sample B.
F.
PAD FX Send - Controls the amount of signal from
the pad that goes to the FX channel from 0 - 127.
A low value will have a small amount of the effect
blended in; a high value will be entirely affected.
User Manual
LOOP
Adjust built-in and user recorded loops within the
nPad. More information about recording loops on
page 13.
E
A
B
C
D
A.
KIT - The name of the preset kit sound being used by
the MIDI.
B.
MIDI - Name of MIDI pattern or loop select. Press OK
to play and press again to pause.
C.
SPEED - Controls the playback tempo of the loop,
from 20 - 240bpm.
D.
VOLUME - Controls the overall volume of the loop.
E.
You can select a pad to play a MIDI loop once hit. Hit
the pad you want to select (be sure the cursor is
displaying PAD + number), then press OK. You will
see a * that indicates this pad will trigger a loop rather
than play sound. Pressing OK again will revert the
pad back to its original state.
9