DBDrums Multi Sample Pad Manual Del Usuario página 30

External Pads and Pedals
To properly connect external pads (single and dual
zone) and pedals, refer to page 5.
Button Sub Menu
MIDI
Displays a MIDI number for each pad. Hit a pad and
the corresponding MIDI number will be highlighted.
Once the desired pad has been hit you can edit the
MIDI value using the scroll wheel or +/-buttons.
PAD
Adjusts pad specific parameters.
Sensitivity
Changes how sensitive the pad is, adjust from 1-32.
1 is low sensitivity, 32 is most sensitive.
Threshold
It's the value from 1 to 32 which determines the point
of change between an unwanted signal and a valid
sound. When the threshold is set to a high value,
a soft hit will not be detected and neither generate
any sound.
VelCurve
Sets the way the velocity increases as you hit the pad
harder, choose between linear, log and exp.
› Linear
The default type of velocity. The sample volume
increases evenly as you hit the pad harder.
› Log
The sample volume reaches maximum velocity
quicker. Ideal for samples which doesn't need much
dynamic range to reach the maximum velocity.
› Exp
The sample reaches maximum velocity slower, ideal
for samples that have extra nuance.
ExtPAD
Allows you to adjust extra pads connected to the
nPad (sold separately). To control an additional
footswitch, plug in the footswitch and press it,
this will allow you to adjust its settings.
User Manual
Mode
Allows you to change the behaviour of a connected
footswitch. By default, FS1 will be in HHPedal mode
and FS2 will be in KICK mode.
› HHPedal
In this mode the footswitch will act as if it has a hi-hat
pedal, operating as a control pad.
› PAD
Used to control whether a pad plays sample A or B.
For example, when you press the footswitch down, it
will play sample A - when you let go of the footswitch
it will revert to sample B.
› KICK
Footswitch will act as a kick drum. When pressed it
will play a sample.
› KIT DEC
Operates as the (-) button or like moving the scroll
wheel one value to the left. It can be used to change
presets via footswitch.
› KIT INC
Operates as the (+) button or like moving the scroll
wheel one value to the right. It can be used to change
presets via footswitch.
› CLICK
In this mode the footswitch or pad turns the
metronome off or on.
› MUTE
Press the footswitch to stop sounds.
Control PAD
Selects which pad the footswitch controls in HHpedal
or Pad mode.
Trig1/2
Choose between single or dual zone trigger for the
external pad plugged into Trig 1/2.
Trig3/4
Choose between single or dual zone trigger for the
external pad plugged into Trig 3/4.
12