Cust omizing Your M onit or
Select
LANDING
ADJ
LANDING ADJUST
CANCEL MOIRE *
ADJ
MOIRE ADJUST
* Moire is a type of natural interference which produces soft or
wavy lines on your screen. It may appear due to interference
between the regulated pattern of the picture from the input
signal and the phosphor pitch pattern of the CRT.
Example of moire:
4
Press the >? / / buttons to adjust the settings.
For
H CONVERGENCE
V CONVERGENCE
TOP
V CONVER TOP
14
Downloaded from:
https://www.usersmanualguide.com/
To
select one of the four corners that
needs color correction due to
influence from the earth's magnetism
correct the color at one of the four
corners of the screen
turn the moire cancellation function
"ON" or "OFF." CANCEL MOIRE
must be "ON" for "
ADJ (MOIRE
ADJUST)" to appear on the screen.
adjust the degree of moire
cancellation
Press
/ . . . to shift red shadows to the right
and blue shadows to the left
? . . . to shift red shadows to the left
and blue shadows to the right
/ . . . to shift red shadows up and blue
shadows down
? . . . to shift red shadows down and
blue shadows up
/ . . . to shift red shadows up and blue
shadows down
? . . . to shift red shadows down and
blue shadows up
For
Press
/ . . . to shift red shadows up and blue
BOT
shadows down
V CONVER BOTTOM
? . . . to shift red shadows down and
blue shadows up
/ or ? . . . to select the corner of the
LANDING
: top left
: bottom left
ADJ
/ or ? . . . to reduce any irregularities in
LANDING ADJUST
/ . . . to turn CANCEL MOIRE "ON"
CANCEL MOIRE
? . . . to turn CANCEL MOIRE "OFF"
ADJ
/ or ? . . . to adjust the screen until the
MOIRE ADJUST
Not e
The picture may become fuzzy when CANCEL MOIRE is set to
"ON."
The OSD automatically disappears after about 30 seconds.
To close the OSD, press the MENU button again.
To reset, press the RESET button while the OSD is on.
The selected item is reset to the factory setting.
screen you want to adjust
: top right
: bottom right
the color to a minimum
50
OFF
ON
OFF
ON
moire is at a minimum
50