Publicidad
Idiomas disponibles
Idiomas disponibles
St ep 2: Connect t he pow er cord
With the monitor switched off, connect one end of the
power cord to the monitor and the other end to a power
outlet.
to a power outlet
Power cord (supplied)
St ep 3: Turn on t he m onit or and com put er
The installation of your monitor is complete.
Not e
If "OUT OF SCAN RANGE" or "NO INPUT SIGNAL" appears on
the screen, see "Warning Messages" on page 20.
For cust om ers using Window s 95/98
To maximize the potential of your monitor, install the new model
information file from the supplied Windows Monitor Information
Disk onto your PC.
This monitor complies with the "VESA DDC" Plug & Play
standard. If your PC/graphics board complies with DDC, select
"Plug & Play Monitor (VESA DDC)" or this monitor's model name
as the monitor type in the "Control Panel" of Windows 95/98.
If your PC/graphics board has difficulty communicating with this
monitor, load the Windows Monitor Information Disk and select
this monitor's model name as the monitor type.
For cust om ers using Window s NT4.0
Monitor setup in Windows NT4.0 is different from Windows 95/98
and does not involve the selection of monitor type. Refer to the
Windows NT4.0 instruction manual for further details on adjusting
the resolution, refresh rate, and number of colors.
Downloaded from:
https://www.usersmanualguide.com/
to AC IN
Get t ing St art ed
Aut om at ically Adjust ing t he Size
and Cent ering of t he Pict ure
By pressing the auto sizing and centering (ASC) button, the
size and centering of the picture are automatically adjusted
to fit the screen.
1
Turn on the monitor and computer.
2
Press the ASC button.
The picture is adjusted to fit the center of the screen.
ASC
Not es
• This function is intended for use with a computer running
Windows or similar graphic user interface software that
provides a full-screen picture. It may not work properly if the
background color is dark or if the input picture does not fill the
screen to the edges (such as an MS-DOS prompt).
• The screen may go blank for a few seconds while performing the
auto-sizing function. This is not a malfunction.
• Although the signals for picture aspect ratio 5:4 (resolution: 1280
× 1024) do not fill the screen to the edges, the picture is
accurately displayed.
Select ing t he On-screen Display
Language
If you need to change the OSD language, see "Using the
LANG (Language) On-screen Display" on page 17.
The default setting is English.
Get t ing St art ed
7
EN
F
ES
C
Publicidad
