Bollhoff RIVKLE B2007 Manual De Uso página 36

2 - Preparation for use
Adjusting the position of the anvil in relative to the mandrel
• The position of the anvil depends on the length of the RIVKLE
• The position of the anvil should be adjusted as shown in figure 5.
• After adjustment, tighten the anvil locknut (2) to 10 Nm.
Flush mandrel on the end of the RIVKLE
Fitting with standard capscrew DIN912:
M3
M4
COMMON
M5 ADAPTATOR
236 166 00 300
M6
M8
36
OPEN RIVKLE
®
®
Figure 5 - Adjustment of the anvil position
2
3 1
4
236 803 03 010
236 803 04 010
236 803 05 010
236 803 06 010
236 803 08 010
before setting.
®
SEALED RIVKLE
Thread root single-turn mandrel
COMMON ADAPTATOR
4
3
236 803 03040
236 803 04040
236 803 05040
236 803 06040
NA
®
1
M3 x 45 12.9
M4 x 55 12.9
M5 x 60 12.9
M6 x 65 12.9
M8 x 65 12.9