Bollhoff RIVKLE B2007 Manual De Uso página 49

7 - Warning list
In case of abnormal conditions during operation, the "warning" page will indicate the alarm and the
possible solution.
No. Text on the display
1
M1 engine current high
2 M2 engine current high
3 Wrong Battery
4 Not Ready, press RESET
5
Low Battery Voltage
6
Setting time too long
7 Screwing/unscrewing time too long
8
Bad M1 Position, press RESET
9
Pressure, Please Check Oil
10 Load Not Correct
11
M1 Motor, High Temperature
12
M2 Motor, High Temperature
13 Drive, High Temperature
14
Load a Rivet
15
Error communication
16 Error communication
17
Wrong Battery
18
Nose not installed
19
Home sensor error
20
Service required in 5000 cycles
21
Maintenance service needed
22
LCD pushbutton pressed
Solution
Reduce the force
Contact the Assistance Service
Replace the battery and use only the batteries
provided
Press RESET
Replace the battery
Check the oil level or replace the battery
Contact the Assistance Service
Check the oil level and press Reset
Check the oil level
-
Wait a few minutes before resuming work
Wait a few minutes before resuming work
Wait a few minutes before resuming work
Load a RIVKLE on the mandrel
®
Contact the Assistance Service
Contact the Assistance Service
Replace the battery with a correct one
Check that the nose is correctly installed against
the body
Press "Reset" button to drive the system
to rest position
Contact the Assistance Service
Contact the Assistance Service
or carry out the maintnenance operations
Check that the different button are free / body
49