Publicidad
Idiomas disponibles
Idiomas disponibles
The control lamp shines so long, since the thermostat switches off the device with reaching of the
•
opposed ambient temperature and begins again if the thermostat again turns on the device.
If the steps switch turned on position
•
lamp goes out.
OVERHEATING SAFETY DEVICE
To prevent damage and risks due to overheating, the built-in overheating safety device cuts off the
power as soon as the heating elements become too hot.
MAINTENANCE
We recommend that you clean your heater at least twice a year to remove accumulated dust and dirt.
Set the selector switch to position
-
Wait for the heater to cool down sufficiently.
You may clean the outside of the heater with a damp cloth or brush. Do not use water or allow
-
water to come into the appliance. Do not use any abrasive and caustic cleaning agents!
Never touch the heater in water! Danger to life!
-
Clean the air inlet and outlet grilles regularly with a vacuum cleaner, using the brush attachment.
-
Storage
Keep the original box in which the heater was packed to store it during the warmer months when it is
not in use. Clean the heater according to the instructions under Cleaning.
Pack the heater in the original box and store it in a cool, dry place.
TECHNICAL CHARACTERISTICS
Model: CR 5036 CR 5037
Voltage: 220 V – 240 V
Power: Maximum 1800 W (900 W – 1800 W)
Tension: 50 Hz.
or the device by the electricity mains is taken, the control
to switch off. Remove the mains plug from the wall socket.
14
Publicidad
