Gaggenau RC472704 Instrucciones De Uso página 9

Before using for the first time
1.
Remove information material, adhesive tape and
protective foil.
2.
Clean the appliance.
~ "Cleaning" on page 22
Electrical connection
9
CAUTION
Do not connect the appliance to electronic energy
saver plugs.
Note: You can connect the appliance to mains-controlled
and sine-controlled inverters.
Mains-controlled inverters are used for photovoltaic
systems which are connected directly to the national grid.
Sine-controlled inverters must be used for isolated
applications. Isolated applications, e.g. on ships or in
mountain lodges, are not directly connected to the
national grid.
1.
After installing the appliance, wait at least 1 hour
before connecting it to prevent damaging the
compressor.
2.
Check that the outlet was installed according to the
regulations and complies with the requirements.
Requirements for outlets
Outlet with
Protective conductor
Fuse
Maximum simultaneous load
Appliance
3.
Connect the appliance to an outlet near the appliance.
The outlet must also be freely accessible following
installation of the appliance.
9
WARNING
Risk of electric shock!
Never use multiple outlets, extension leads or
adapters.
The appliance must be correctly grounded.
Never cut through or remove the third (ground)
conductor of the power cord.
110 V ... 120 V
60 Hz
10 A ... 16 A
6 A
Installation and connection
Risk of electric shock!
If the length of the power cord is inadequate,
never use multiple outlets or extension leads.
Instead, please contact Customer Service for
alternatives.
en-us
9