Publicidad
Idiomas disponibles
Idiomas disponibles
WALL MOUNTING / STORAGE INSTRUCTIONS
Your inflator has built-in features for conveniently wall mounting the unit
FOR STORAGE ONLY.
Remove inflator from wall mount and place on a hard clean surface before operating. Use the
included hardware to wall-mount the unit. Take extra care to ensure there is no wiring, plumbing,
or other objects located within the wall behind your chosen mounting location. Manufacturer is
not responsible for any damage or losses incurred from complications in wall-mounting.
For Drywall mounting:
1. Make a mark for two vertical mounting locations on wall 3⅞" / 98 mm apart.
2. Using ¼" drill bit, drill holes at the marked locations.
3. Using a hammer, tap in the wall anchors until flush with the wall
4. Using a screwdriver or screw gun, install the screws into the wall anchors, leaving
approximately ⅜" protruding from the wall.
5. Hang the inflator on the screws using the recesses located on the back of the inflator.
Publicidad
