10.5 R
EPLACING THE BATTERY
Should the instrument appear to be giving much shorter endurance than described
in appendix Technical specifications even when fully recharged, it may be that
the battery is damaged or spent.
Purchase a new battery from an Inventis-approved dealer; proceed to replace the
existing battery from the instrument as described below:
-
Switch off the instrument and disconnect it from the USB cable;
-
Position it face down (display directed downwards) on a soft surface;
-
Undo the screw retaining the flap of the battery compartment;
-
Remove the battery. Separate the connectors without tugging; ease apart
using tweezers;
-
Fit the connector of the new battery;
-
Position the lead inside the compartment below the screw and locate the
new battery in its housing, then close the flap and secure with the
retaining screw.
Recharge the instrument completely before use.
All accessories mentioned in the manual are designed especially for
use with this instrument. Only accessories supplied by Inventis should
be connected to the tympanometer.
10.6 R
EPAIRS AND TECHNICAL ASSISTANCE
Before contacting the service department, make certain that all the possible
solutions in appendix Troubleshooting have been tried.
Parts that are to be returned to the manufacturer must be cleaned and sanitized,
following the directions in this manual. Transducers must be shipped in a closed
and sealed transparent bag.
Should the instrument need to be sent to the service department or returned to
the dealer, it is important that the original packing be used, and that all
accessories and transducers are enclosed.
EN
39