Cembre SD-15P-ECO Manual De Uso Y Mantenimiento página 7

3.5) "VAL-SD" case
Steel case suitable for storing both the complete
drilling machine (disassembled detachable guard)
and the VAL-P6 accessory case.
4. DRILLING
4.1) Preparing the drilling machine
Remove drilling machine, detachable guard and
auger from storage case.
Stop the engine before removing the auger
4.1.1) Fitting and removing the auger (See Fig. 1a)
Select the auger suitable for the work to be done:
– Turn the emergency lever (12) and fully insert the auger.
– Release the emergency lever.
– Manually rotate the auger until a click is heard, indicating automatic locking.
To remove the auger: turn the emergency lever, manually rotate and remove the auger from the
spindle.
4.1.2) Assemble the TPM... guard nozzle (Ref. to Fig. 1b)
– Select the guard nozzle suitable for the hole to be drilled (Ref. to § 3.2):
– Fully screw counter-clockwise the guard nozzle (1) into the detachable guard PRM-UN.
4.1.3) Assemble the guard PRM-UN (Ref. to Fig. 1c)
To fi t the detachable guard PRM-UN proceed as follows:
– Rotate two latches (3) into the vertical position.
– Slide the detachable guard PRM-UN onto the shafts.
– Rotate the latch (3) into the horizontal position to lock the guard.
7
3.4) "VAL-P6" case
Case suitable for storing all the accessories supplied with
the drilling machine together with a series of augers.
VAL-P VAL-P6
ENGLISH
VAL-SD VAL-SD