Cembre SD-15P-ECO Manual De Uso Y Mantenimiento página 8

ENGLISH
4.1.4) Setting the hole depth (See Fig. 1d)
Open the lever and loosen the adjuster (26).
Position the adjuster to the desired depth on the graduated scale. Tighten the adjuster and
close the lever (23).
During the drilling operation, the adjuster butts against the detachable guard at the preset
hole depth to prevent any further travel of the auger.
4.1.5) Setting the rotation direction (ONLY SD-15PR-ECO)
The rotation direction of the spindle is set using the 3 position
selector (33):
: right sense of rotation, for drilling.
: idle position (main shaft gears disengaged).
: left sense of rotation, to allow the auger to be
disengaged when blocked in the wood.
WARNING: adjustment of selector (33) must always be carried out with the engine switched
off or idling to ensure correct engagement of gears.
4.2) Using the drilling machine
The drilling machine can be used independently or in conjunction with the support trolley:
4.2.1) Using the drilling machine "independently" (Ref. to Fig. 5)
– ONLY SD-15PR-ECO: make sure the rotation direction selector (33) is in position "N" (idle
position).
– With the drilling machine on the ground, follow the instructions in § 6.
Allow the machine to "warm up" for 2 minutes prior to commencement of work.
– Locate the machine on the sleeper in the desired position, locate the guard end piece TPM
into the bush of the chair and proceed as § 4.2.3.
4.2.2) Using the drilling machine with the support trolley (Ref. to Fig. 6).
– ONLY SD-15PR-ECO: make sure the rotation selector (33) is in position "N" (idle position).
– Follow the instructions in § 6 and allow the machine to "warm up" for 2 minutes prior to
commencement of work.
– Using the main handle on the drilling machine, move the trolley over the sleeper to the desired
hole position and locate the guard end piece TPM in the bush of the chair.
Note: For use of the support trolley, refer to specifi c "Operation and Maintenance Manual".
Reference
33
8