Scan Mode; Using The Radio In Scan Mode - Uniden UM425 Manual Del Usuario

Getting Started

Scan mode

You can save channels into memory and then use scan mode to monitor
those channels. When the radio detects a signal on a channel, it pauses on
that channel as long as the signal is received; when the transmission stops,
the radio will continue scanning.
When it detects a signal, the radio stays on the
channel until you press the
signal stops.
08 10
The radio scans about
5 channels in 1 second.
In scan mode, you can get the following information from the display (some
indicators will not always be displayed):
Transmit power
last used
All scanned
channels must
be in memory
Normal scan
mode or Triple/
Dual-watch on

Using the radio in scan mode

• You cannot transmit while in scan mode.
• You must have two or more channels in memory to start a scan.
• To save a channel into memory, select the channel, then press and
hold the
display.
11 12 13
1 Watt
Memory
Scanning Channels
01A,03A,05A,06,07A,08
button for two seconds. Memory will show on the
SCAN-MEM
button or the
CHANNEL UP
07
USA
E-14
Resume scan
17
20
15
Channel mode
(USA, CANadian,
or INTernational)
Current
channel being
scanned
Scan list (if the
text is too long,
the line scrolls)