Guide For Use; Before Machine Start-Up; Brush / Pad-Holder Installing And Removal - Clarke CA30 17E Instrucciones De Uso

A - ENGLISH

GUIDE FOR USE

WARNING !
On certain parts of the machine are pasted some indicative signs:
DANGER !
WARNING !
CAUTION !
CONSULTATION
When reading this manual, the operator must pay particular attention to the symbols on these labels. Under no circumstances shall these labels be
covered. If they are damaged, please replace them immediately.

BEFORE MACHINE START-UP

BRUSH / PAD-HOLDER INSTALLING AND REMOVAL

NOTE
According to the type of fl oor to be cleaned, the machine may be installed with brush (Figure 3, A), or a pad-holder (Figure 3, B and
C).
CAUTION !
When manually installing or removing the brush/pad-holder, fi rst ensure that all the switches are in the "off" position and lift the
squeegee off the fl oor. Only after which can the brush or pad-holder be worked on.
Always wear protective gloves.
1. Make sure the power cable (9) disconnecting the power supply and the switch (38) is at
the disconnecting (Off) condition.
2. Press down the handle (2) to lift the tank body (26).
3. Put the brush (A) or the pad-holder (B – C) under the case.
4. Use the handle (2) to lower the tank body (26) to come into contact with the brush or
pad-holder.
5. Manually attach by following the arrow head (D) to install the brush/pad-holder (as shown
in Figure 3).
6. Remove by turning the brush/pad-holder in the opposite direction and it can be taken off.
(Figure 3)
SQUEEGEE ADJUSTING
7. Install the squeegee and tighten the knobs. Then connect the vacuum hose to the
squeegee assembly.
8. Adjust the squeegee through the adjusting handle (A) of the squeegee (Figure 4).
1. If the mid-section of the rear squeegee bracket, section B, has a gap with the fl oor
or the downward pressure is relatively light, adjust the handle in an anti-clockwise
direction until the whole length of the rear squeegee strip touches well with the fl oor.
The front squeegee strip should lightly touch the fl oor.
2. If the two ends of the rear squeegee strip, sections C and D, have a gap with the
fl oor or the downward pressure is relatively light, adjust the handle in a clockwise
direction until the whole length of the rear squeegee strip touches well with the fl oor.
The front squeegee strip should lightly touch the fl oor.
A - 8
INSTRUCTIONS FOR USE
CA30 17E - 56091131
FRONT
FIGURE 3
7/2014