Tripp-Lite 040-008-19 Guia De Inicio Rapido página 3

Single-Stage Installation
1. Before starting the installation, shut down all computers that are to be
connected to the KVM switch.
2. Connect the external power supply (B042-Series KVMs) or power
cord (B040-Series KVMs) to the unit, and then plug it into a
Tripp Lite Surge Protector, PDU or Uninterruptible Power Supply
(UPS).
3. B042-Series KVM Switches Only: Connect a USB or PS/2 keyboard,
a mouse and a monitor to the console ports on the back of the KVM
switch.
Note: Any combination of mouse and keyboard will work; PS/2 keyboard and
mouse, USB keyboard and mouse, PS/2 keyboard and USB mouse, USB
keyboard and PS/2 mouse.
4. B040-Series Console KVM Switches Only: Connect an external
USB mouse or keyboard and an external monitor to the corresponding
external console ports on the back of the unit. You can also add
remote access to the KVM switch by connecting a B051-000 IP
Remote Access unit to the external console ports on the back of the
unit. (See the B051-000 owner's manual for details on installation.)
Note: If you are not using the External VGA Monitor port, you must connect
the External VGA Port Terminator to it for the unit to function properly.
5. Using Tripp Lite P780-Series USB/PS2 Combo KVM Cable Kits,
connect a computer to an available computer port on the back of
the unit. Repeat this step for each additional computer you are
connecting.
6. Power on the connected computers.
3