Tripp-Lite 040-008-19 Guia De Inicio Rapido página 7

KVM Operation
Ports on the NetController KVM Switches can be accessed via
Pushbuttons, Hotkeys or OSD. In addition, the OSD allows you to
perform various operations on the KVM switch.
To switch to a port via Pushbutton, simply press the Push-button of the
port that you wish to access. To access ports via hotkey commands, or
use the OSD to operate the KVM switch, see the table below:
Hotkey Hotkey
Command Sequence
Select port [Scroll Lock]
[Scroll Lock]
(Single-stage
installation) ab = 2-Digit Port
Number (01 – 16)
[Scroll Lock]
Select port
(Daisy-chain [Scroll Lock]
installation) ab, yz
ab = 2-Digit
Station Number
(01 – 16)
yz = 2-Digit Port
Number (01 – 16)
Next Lower [Scroll Lock]
Port [Scroll Lock]
Next Higher [Scroll Lock]
Port [Scroll Lock]
Next Lower [Scroll Lock]
[Scroll Lock]
Station
[Page Up]
Next Higher [Scroll Lock]
Station [Scroll Lock]
[Page Down]
Beep On/Off [Scroll Lock]
[Scroll Lock]
Initiate an Auto [Scroll Lock]
Scan [Scroll Lock]
Title Bar On/ [Scroll Lock]
Off [Scroll Lock]
[Scroll Lock]
Reset Console
Mouse [Scroll Lock]
[End]
OSD Procedure
1
, In the OSD Main Page,
2
, ab highlight the desired port using
2
the up and down arrow keys
([Page Up] and [Page Down]
displays additional ports) and
press the [Enter] key.
, In the OSD Main page,
2
highlight the desired port using
2
the up and down arrow keys
([Page Up] and [Page Down]
displays additional ports and
KVMs) and press the [Enter]
key.
, —
2
, [↓]
2
, —
2
, [↑]
2
, —
2
,
2
, —
2
,
2
, —
2
, [B]
2
, Press the [F2] key when in
2
, [S] any of the OSD Pages.
2
, —
2
, [T]
2
, —
2
,
2
7
Description
Switches console focus to the
selected port.
Switches console focus to the
selected KVM switch and port.
Switches console focus from
the current port to the next
accessible port prior to it.
Switches console focus from
the current port to the next
accessible port after it.
Switches console focus from
the current port to the first
accessible port on the next
lower-level KVM switch.
Switches console focus from
the current port to the last
accessible port on the next
higher-level KVM switch.
Toggles the Beeper On/
Off. The Beeper sounds
when performing a Hotkey
Command or during an Auto
Scan.
Initiates an Auto Scan. Press
any key to stop an Auto Scan.
Turns the Title Bar On/Off.
Note: This does not affect the Title
Bar setting in the OSD.
Resets the console mouse in
the event of a lockup.