Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the Light Kit
Pan/Light Kit Fitter
Assembly/ Light Shade
CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing the light kit.
1. Loosen but do not remove two of three
mounting screws from the fan motor
assembly; Remove one mounting screw.
(Figure 16)
2. Push the light kit pan up to the fan motor
assembly so that the two loosened screw
heads fit into the keyhole slots. Turn the
light kit pan clockwise, and tighten the
screws. Re-install the screw that was
removed in step 1 and tighten firmly.
(Figure 16)
3. Remove one screw from the light kit pan,
and loosen but do not remove the other two
screws. Connect the wires from the light
kit fitter assembly to the wires from the fan
motor assembly by connecting the molded
adaptor plugs together. Carefully tuck
all wires and splices into the switch cap.
(Figure 17)
9.
4. Push the light kit fitter assembly up so
that the two loosened screw heads fit into
the keyhole slots. Turn the light kit fitter
assembly clockwise, tighten the screws. Re-
install the screw that was removed in step 3
and tighten firmly. (Figure 17)
5. Place the light shade into the light kit pan,
aligning the three flat areas on the top of the
light shade with the three raised dimples
in the light kit pan. Turn the light shade
clockwise until it stops. (Figure 18)
PERIODICALLY CHECK THE GLASS SHADE IS
SEATED FULLY CLOCKWISE IN THE LIGHT KIT
PAN ASSEMBLY.
Screws
Blue
Black
Light kit
pan
Figure 16
Light kit
White
pan
Light kit
fitter
assembly
Screws
Figure 17
Light kit
pan
Light shade
Figure 18
Publicidad
