STEINEL XLED PRO 240 S Manual De Instrucciones página 18

Note:
After the LED floodlight switches OFF, it takes
approx. 1 second before it is able to start detecting
movement again. The LED floodlight will only
switch ON in response to movement once this
period has elapsed.
• Fit ring cover on sensor unit. (Fig. 6.3)
Other information:
Floodlight adjustment range (Fig. 6.4)
Shrouds (Fig. 6.5)
The film shroud can be used for masking out any
number of lens segments to limit reach as required.
Inadvertent triggering is ruled out or the sensor can
be targeted to watch over danger spots (Fig. 6.6).
Setting functions
– Setting via control dial
Note:
The settings last selected on the control will be used.
7. Operation/maintenance
The LED floodlight is not suitable for burglar alarm
systems as it is not tamperproof in the manner pre-
scribed for such systems. Weather conditions may
affect the way the LED floodlight works. Strong
gusts of wind, snow, rain and hail may cause the
light to come ON when it is not wanted because
the sensor is unable to distinguish between sudden
changes in temperature and sources of heat.
The detector lens may be cleaned with a damp
cloth if it gets dirty (do not use cleaning agents).
Important note: the control gear cannot be replaced.
8. Disposal
Electrical and electronic equipment, accessories
and packaging must be recycled in an environmen-
tally compatible manner.
Do not dispose of electrical and
electronic equipment as domestic
waste.
EU countries only: Under the current European
Directive on Waste Electrical and Electronic Equip-
ment and its implementation in national law, electri-
cal and electronic equipment no longer suitable for
use must be collected separately and recycled in
an environmentally compatible manner.
9. Manufacturer's Warranty
Manufacturer's warranty of STEINEL GmbH,
Diesel strasse 80-84, DE-33442 Herzebrock- Clarholz,
Germany
All STEINEL products meet the highest quality
standards. For this reason, we, the manufacturer,
are pleased to provide you, the customer, with a
warranty under the following terms and conditions:
The warranty covers the absence of deficiencies
which are proven to be the result of a material
defect or fault in manufacturing and which are
reported to us immediately after detection and
within the warranty period. The warranty shall cover
all STEINEL Professional products sold and used in
Germany.
Our warranty cover for consumers
The provisions below apply to consumers. A con-
sumer is any natural person who, on entering into
the purchase transaction, neither acts in exercising
their commercial nor their self-employed activity.
You can opt for warranty cover in the form of
repair or replacement which will be provided free
of charge (if applicable, in the form of a successor
model of the same or higher quality) or in the form
of a credit note.
In the case of sensors, floodlights, outdoor and
indoor lights, the warranty period for the STEINEL
Professional product you have purchased is
5 years in each case from the date on which the
product was purchased.
We shall bear the shipping costs but not the trans-
port risks involved in return shipment.
Our warranty cover for entrepreneurs
The provisions below apply to entrepreneurs.
Entrepreneur is a natural or legal person or
partnership with legal personality who or which,
on entering into the purchase transaction, acts in
exercising their or its commercial or self-employed
activity.
– 18 –