Olympia A 245 Combo Manual De Instrucciones página 24

Clearing Pouch Jams
Pouches can jam due to the following:
■ the laminating pouch was not straight when inserted in the infeed
■ the transport rollers are soiled with residual adhesive.
■ an unsuitable laminating pouch or material has been used.
1
Set the On/Off switch
2
Disconnect the power plug from the power socket.
3
RELEASE lever
Slide the
Ä This releases the laminating pouch.
Caution! Risk of burns through hot machine surface! During the laminating process,
the machine surface heats up. Wait a few minutes after laminating until the laminator
has cooled down before you touch it.
4
Carefully pull the laminating pouch out of the infeed
Caution! Risk of burns through hot laminating pouch. When the laminating pouch is
ejected after lamination, it is extremely hot. Only remove the lamination pouch by
holding it at the cooled end.
5
RELEASE lever
Let go of the
Ä The pouch jam has been cleared.
Maintenance and Service
Clean the laminator at regular intervals and as necessary.
Cleaning the Housing
1
Set the On/Off switch
2
Disconnect the power plug from the power socket.
Caution! Risk of burns through hot machine surface! During the laminating process,
the machine surface heats up. Wait a few minutes after laminating until the laminator
has cooled down before you touch it.
3
Use a slightly damp, lint-free cloth to clean the surface of the laminator. Do not use any
solvents or cleaning agents.
Ä The surface of the laminator has been cleaned.
24
to OFF (O).
7
to the right and hold it in this position.
3
.
3
to OFF (O).
7
of the laminator.
12
g
of the laminator.
9