Husky 2G110DPNG Manual De Instrucciones página 15

USING THE INFLATION HOSE WITH THUMB-
LOCK CONNECTOR
Inflating balls, rafts and toys:
See Figures 10 - 11.
Make sure the ball-valve at the base of the inflation
hose is in the OFF position (vertical to the hose) (Fig.
6).
With the thumb-lock connector lever in the open
position (Fig. 10), insert the appropriate inflation needle
or nozzle into the connector and fold the lever over (A)
until it is locked securely (Fig. 11).
Ensure the compressor is plugged-in and switch to the
"ON" position.
Open the ball-valve at the base of the inflation hose
to begin inflating (Fig. 9). You may adjust air flow by
turning the ball valve between 0 – 90 degrees (do not
over-inflate).
Turn ball-valve to the "closed" position (Fig. 6) when
inflation is complete.
OPERATION
THUMB-LOCK CONNECTOR LEVER
IN THE OPEN POSITION
15
Fig. 10
FOLD THE LEVER OVER
UNTIL IT IS LOCKED SECURELY
A
Fig. 11