Yamaha ATS-1080 Manual De Instrucciones página 6

▪ Do not disassemble a battery.
If the contents of the battery get on your hands or in your eyes, it can
cause blindness or chemical burns.
▪ Do not dispose of a battery in fire.
Do not expose a battery to high temperatures, such as direct sunlight or a
fire.
Doing so may result in the battery bursting, causing a fire or injury.
▪ Do not attempt to recharge batteries that are not intended to be charged.
Charging could cause the battery to burst or leak, which can cause
blindness, chemical burns, or injury.
▪ If the batteries do leak, avoid contact with the leaked fluid.
Battery fluid is corrosive and may possibly cause loss of sight or chemical
burns. If the batteries do leak, avoid contact with the leaked fluid. If the
battery fluid should come in contact with your eyes, mouth, or skin, wash
immediately with water and consult a doctor.
Wireless unit
▪ Do not use this unit near medical devices or inside medical facilities.
Radio waves from this unit may affect electro-medical devices.
▪ Do not use this unit within 15 cm (6 in) of persons with a heart pacemaker
implant or a defibrillator implant.
Radio waves from this unit may affect electro-medical devices, such as a
heart pacemaker implant or defibrillator implant.
CAUTION
This content indicates "risk of injury."
Power supply
▪ Do not use an AC outlet where the power plug fits loosely when inserted.
Failure to observe this may cause a fire, electric shocks, or burns.
▪ When disconnecting the power plug, always hold the plug itself and not
the cord.
Pulling by the cord can damage it and cause electric shocks or a fire.
▪ Insert the power plug firmly all the way into the AC outlet.
Using the unit when it is not plugged in sufficiently can cause dust to
accumulate on the plug, causing a fire or burns.
Installation
▪ Do not place the unit in an unstable position where it might accidentally
drop or fall over and cause injuries.
▪ When installing this unit, do not obstruct heat dissipation.
– Do not cover it with any cloth.
– Do not install it on a carpet or rug.
– Do not block this unit's ventilation holes (cooling slits).
– Do not install the unit in other ways than indicated.
– Do not use the device in a confined, poorly-ventilated location.
Failure to observe the above may trap heat inside the unit, causing a fire or
malfunctions. Ensure that there is adequate space around the unit: at least
10 cm (4 in) on top, 10 cm (4 in) on the sides, and 10 cm (4 in) on the rear.
▪ Do not install the unit in other ways than indicated.
Failure to observe this may cause malfunctions or for the unit to fall and
cause injury.
▪ Do not install the unit in places where it may come into contact with
corrosive gases or salt air or places that have excessive smoke or steam.
Doing so may result in malfunction.
▪ Avoid being near the unit during a disaster, such as an earthquake.
Since the unit may turn over or fall and cause injury, quickly move away
from the unit and go to a safe place.
▪ Before moving this unit, be sure to turn off the power switch and
disconnect all connection cables.
Failure to observe this may damage the cables or cause you or someone
else to trip and fall.
▪ For proper mounting the unit on a wall, make sure to have it done by the
dealer from where you purchased the unit or by qualified service
personnel.
Failure to observe this may cause the installation to fall and result in injury.
Installation requires special skills and experience.
6
En