CASO DESIGN VR 390 advanced Manual Del Usuario página 37

PLEASE NOTE
► Press the bag to expel excess air before vacuuming it. Too much air inside the bag may
result in a poor vacuum.
► If the food you're sealing has sharp edges (such as bones or shells) pack the edges
with kitchen paper to avoid tearing the bag
► When vacuum sealing liquid-based foods (such as soups or stew) freeze them first in a
baking pan or tempered dish before bagging and vacuum sealing them.
► Blanch vegetables by cooking them briefly in boiling water. Allow them to cool then
vacuum seal them in convenient portions.
► When vacuum sealing unfrozen food, allow at least two additional inches of bag length
for expansion while freezing. Place unfrozen meat or fish on a paper towel and vacuum
seal with the paper towel in the bag to absorb any extra moisture.
► Before storing foods such as tortillas, crepes or bread, use wax or parchment paper
between them to stack the pieces. This will make it easier to remove an individual piece,
reseal the rest and immediately replace them in the freezer.
17.5 Vacuum package in a Canister
Wipe canister cover and canister and ensure they are clean and dry.
To ensure there is no air leaking between the cover and the canister,
use your hand to push down the cover at the beginning of the vacuum
operation. The device will stop automatically when enough vacuum pressure is achieved.
Remove the vacuum hose from the cover of container first then from the air intake at
device. Replace drip tray into vacuum chamber.
You can cancel the operation at any time by pressing button for canisters (6) again.
17.6 Storage
Store the device in its upright position, out of the reach of children.
PLEASE NOTE
► Always unplug the appliance from its outlet immediately after using and before
cleaning.
► For the correct storage, please slightly close the cover, do not lock, it will deform the
gaskets and affect the machine function.
Fill the vacuum goods into the
container. Be careful not to fill in
too much vacuum goods.
Remove the drip tray from the
vacuum chamber. Connect one end
of vacuum hose at the air intake at
device and other end at connector
at canister cover or with adapter at
the canister cover.
Press button for canisters (6).
37