Imetec L1901 Instrucciones Para El Uso página 14

EN
1. Handle
1a. asola
1B. kit di supporto
2. Handle fastening screw
3. Battery Cover
4. Battery cover screw
5. Data plate
6. charging contact
7. plug
8. ON/OFF switch
9. power regulation button
• loosen the fastening screw (2) of the handle (1) and remove it.
• attach the handle (1) to the body of the appliance, taking care to assemble it correctly
[Fig. b1].
• insert the fastening screw (2) and tighten it clockwise with the aid of a screwdriver.
• apply the brush (13) to the suction coupling until the brush release button clicks (12)
[Fig. c1].
Your appliance is equipped with the following attachments:
• BRUSH (13): is suitable for all surfaces: ceramic, marble, parquet and rugs.
ATTENTION!
Only use the original battery charger supplied with the appliance.
DO NOT charge the appliance with temperatures lower than 0° and
higher than 40°.
Before using the appliance for the first time, the battery must be
completely charged.
CHARGING THE BATTERY
• make sure the appliance is set to oFF before recharging it.
• Fit the feeder (7) into the recharge contact (6) [Fig. D1].
• Connect the plug (7) to the socket.
• the battery status leD (15) remains red during recharge.
• the power level/Battery charge level leDs (10) will blink while charging, then they will
turn steady as the charge level has reached 1/3, 2/3 and 3/3.
• When the battery is fully charged the battery status leD (15) turns green and the three
power leDs remain on to alert to successful recharge.
• When the appliance is completely charged the control circuit for the battery interrupts
automatically, protecting it from any damage.
• it is completely normal for the plug to heat up during charging.
• Charge the appliance after each use to ensure it is always in good working order.
• For long periods of inactivity, disconnect the plug (4) to avoid dispersing any energy.
• in long periods of inactivity, recharge the batteries at least every 3/4 months.
12
10. power level/battery charge level leDs
11. Dust collection system
11 a. Dust collection compartment
11 b. Filter protection mesh
11 C. Cyclonic filter
11 D. MaX level
12. brush release button
13. brush
14. Dust collection system release lever
15. Battery status leD.
ASSEMBLY
ACCESSORIES
PREPARATION