Flex FX1231 Manual Del Operador página 11

INSTALL AND REMOVE BITS
(FIG. 3, 4, AND 5)
WARNING
loosen or tighten the chuck jaws on the bit.
Friction burn or hand injury is possible if
attempting to grasp the spinning chuck.
WARNING
Your tool is equipped with a keyless chuck to
tighten or release bits in the chuck jaws. The ar-
rows on the chuck indicate the direction in which
to rotate the chuck body in order to tighten
("LOCK") or release ("UNLOCK") the chuck jaws
on the bit.
To install the bit:
a. Lock the variable-speed trigger switch "OFF"
on the tool by placing the direction-of-rotation
selector in the center position.
b. Remove the battery pack. Rotate the chuck
body counterclockwise, as shown in Fig. 3,
to open the chuck to approximately the bit
diameter.
c. Insert a clean bit up to the drill-bit flutes for
small bits, or as far as it will go for large bits
(Fig. 3).
d. Close the chuck by rotating the chuck body
clockwise and securely tighten by hand
(Fig. 4).
To remove the bit:
a. Rotate the chuck body counterclockwise, as
shown in Fig. 3, to open the chuck.
b. Remove the bit.
WARNING
chuck jaws. Do not insert the drill bit into the
chuck jaws at an angle and then tighten the
chuck as shown in Fig. 5. This could cause
the drill bit to be thrown from the tool, resulting
in possibly serious personal injury or damage to
the chuck.
WARNING
from the tool, or first allow the bit to cool
down. The bit may be hot after prolonged use.
Do not use the tool while
grasping the chuck to
Do not use bits with
damaged shanks.
Make sure to insert the
drill bit straight into the
Use protective gloves
when removing the bit
Fig. 3
Keyless
Chuck
Fig. 4
Fig. 5
-11-