Stihl MS 261 C-Q Manual De Instrucciones página 45

Installing the spark plug
Insert the spark plug through the
N
grommet and screw it in by hand.
Tighten down the spark plug, fit the
N
boot and press it down firmly.
Install the shroud – see "Shroud".
N
MS 261 C-Q
Replacing the Starter Rope
and Rewind Spring
Removing the fan housing
Remove the shroud – see "Shroud".
N
1
1
Take out the screws (1).
N
Push the hand guard upwards.
N
Pull the underside of the fan
N
housing away from the crankcase
and remove it downwards.
Replacing a broken starter rope
Models with Easy2Start
If suitable circlip pliers are not available,
have the starter rope or rewind spring
replaced by your servicing dealer.
1
Use circlip pliers to carefully remove
N
the circlip (1).
Remove the washer (2), carrier (3)
N
and spring housing (4).
All models
1
3
Use a screwdriver or suitable pliers
N
to remove the spring clip (1) from
the starter post.
Carefully remove the rope rotor with
N
washer (2) and pawls (3).
The rewind spring may pop out and
uncoil during this operation – take care
to reduce risk of injury.
English
4
3
2
1
1
2
3
43