Bianchi E-ARCADEX Manual Del Usuario página 7

DANGER!
Always comply with the torque levels specified on the seat post/expander
clamp. Failure to comply with the recommended torque levels may lead to
malfunction and cause the rider to fall.
SEAT POST
The product is compatible with 31.6 mm diameter seat posts
WARNING!
When removing the seat post never exceed the safety limit indicated on the
component. (Image 1E)
DANGER!
Exceeding the limit may cause the component to malfunction or break,
causing the rider to lose control and fall.
BATTERY COVER AND REMOVAL
To assemble the battery cover, push the upper part of the cover to set it into the frame (Image 1F). Next, tighten the screw located on the cover to
fix it to the frame (Image 1G).
The screw can be tightened by hand, but a screwdriver may be useful.
To remove the battery cover, loosen the screw entirely and lift off the cover.
Image 1F
WARNING!
Do not pull or tug on the cover. Failure to fully unscrew the screw may result in damage to the locking mechanism.
Stop tightening the screw if there is resistance and restart the process from the beginning, aiming to position the cover closer to the frame.
BATTERY LOCK
The battery is secured to the bike with a lock. To remove, unlock it by turning the key provided (clockwise). To install the battery, turn the key
clockwise, push the battery in and release the key. Turn the key anti-clockwise to lock and remove the key. Images 1H and 1J
The product is provided with two keys identified with a code on the tag (see image). Please make a note of this code. In the event that both keys
are lost, a duplicate key can be requested by providing the code directly to the supplier ABUS (www.abus.com).
Image 1G
Image 1E
7