[Battery Pack]
EN
For Appropriate Use of
Bat tery Pack
[Fig.30]
• The rechargeable batteries have a limit-
ed life.
• For optimum battery life, store the Li-ion bat-
tery pack following use without charging it.
• When operating the battery pack, make
sure the work place is well ventilated.
For safe use
• The battery pack is designed to be installed
by proceeding two steps for safety. Make
sure the battery pack is installed properly to
the main unit before use.
• If the battery pack is not connected firm-
ly when the switch is switched on, the over-
heat warning lamp and the battery low
warning lamp will flash to indicate that safe
operation is not possible, and the main unit
will not rotate normally. Connect the battery
pack into the unit of the tool until the red or
yellow label disappears.
Battery Recycling
ATTENTION:
For environmental protection and recycling
of materials, be sure that it is disposed of
at an officially assigned location, if there is
one in your country.
[Battery Charger]
Charging
Read the operating manual for Panasonic
bat tery charger for the battery pack before
charging.
Before charging the battery
Charge the battery at a temperature of 5 °C
(41 °F) to 40 °C (104 °F).
The battery pack cannot be charged at a
temperature of less than 5 °C (41 °F). If the
temperature of the battery pack is less than
5 °C (41 °F), first remove the battery pack
from the charger and allow it to sit for an hour
in a location where the temperature is 5 °C
(41 °F) or warmer. Then charge the battery
pack again.
3. MAINTENANCE
Use only a dry, soft cloth for wiping the unit.
Do not use a damp cloth, thinner, benzine, or
other volatile solvents for cleaning.
4. ACCESSORIES
Charger
• EY0L82
Battery pack for EYFLF / EYFLG
• EYFB30
• EYFB32
Remote control
• EYFA31
Protector for tool
• EYFA15-A (Blue)
• EYFA15-Y (Yellow)
• EYFA15-H (Gray)
• EYFA15-G (Green)
• EYFA15-D (Orange)
Protector for battery EYFB30
• EYFA02-H
Protector for battery EYFB32
• EYFA03-H
Retainer ring for tool EYFLF1XC, EYFLF2XC
• WEYFME1CK077
Tool hanger
• EYFA40
CAUTION:
• Tool hanger is for balancer use only.
Excessive force or impact might break it
and the main unit might fall off.
‒ 26 ‒