Pioneer Kuro KRP-SW01 Manual De Instrucciones página 15

Installing the Product on a TV table etc.
Be sure to observe the following precautions when moving
or installing this product with a Pioneer display and television
into a TV table or other enclosure.
Precautions when moving
• When moving the product more than a few
meters, first remove the speaker, then remove
Caution the Pioneer display and television from the stand
and move the speaker, stand, Pioneer display and
television separately.
• When detaching the Pioneer display and television
from the stand, be sure to follow the procedure
described in "Detaching the Pioneer Display and
Television from the Stand" on page 17.
Precautions when installing in a TV
table or other enclosure
When installing in
a TV table or other
Caution
enclosure, hold the
Pioneer display and television
by the handles located on the
rear of the Pioneer display
and television. If you hold
the speakers, they may be
damaged or twisted.
Preparing the Cables
Use the enclosed cable binder to bind the cables.
Be very careful not to apply force to the bases of the cables on
the Pioneer display and television side.
Using the cable binder
1
Insert the cable binder through the hole on the
top of the rotating platform of the stand.
Cable binder
Hold the Pioneer display and
television by its handles and
from the top.
Installation precautions
Make sure that you always secure a space at least as large
as that shown in the following diagram in front of and behind
the table top stand.
TV table
Min. 30 mm
(1-3/16 inch)
Back
Front
Table top stand
Pioneer display and television
• If the stand
protrudes from the
TV table, it could
Caution
cause unforeseen
accidents such as
the equipment breaking or
falling over.
• When rotating, take care not to allow the
display to bump into walls or surrounding
objects.
 Range of angle rotation
2
Gathering the cables and routing them through
the cable binder.
Min. 30 mm
(1-3/16 inch)
Protrusion is
dangerous.
15
En