Publicidad
Idiomas disponibles
Idiomas disponibles
Damaged cords and plugs have to be repaired or exchanged exclusively in an authorized repair station
(www.weka-elektrowerkzeuge.de).
4.1
Oil bath gear
the SR35/SR75 possesses as all WEKA machines an oil bath gear. Through the special efficient
lubrication, a high duration of life can be reached. Especially take care foe leakages.
If you should realize that oil escapes, stop the machine immediately and send it for a check to one of
our repair stations or directly to us. You can find the addresses on our homepage.
4.2
Water connection
If water escapes from the overflow hole on the water connection ring (item 91), the rotary shaft seals
(item 131 + 133) are to be replaced immediately. This should only be done in an authorized specialist
workshop.
5.
P A R T I C U L A R I N F O R M A T I O N - Please note!
This core drilling machine is only intended for industrial use and may only be operated by trained
personnel.
Proper use extends only to the drilling of rock, concrete and masonry.
For operation, the relevant regulations must be observed.
Power tools must regularly (approx. 6 months) be checked on safety by a specialist.
After any interruption to your work, only switch the core drilling machine on again after you have satisfied
yourself that the drill bit can rotate freely.
Wear ear protection when working with this machine.
6.
G U A R A N T E E
We will guarantee the W EKA core drilling machine for 12 months from the day of delivery. During this
period we will rectify material and production defects free of charge. This warranty does not cover normal
wear and tear, overloading, non-compliance with the operating instructions and intervention by
unauthorized persons or the use of parts from other companies. Further more wearing parts as rotary
shaft seals, overload clutch and ON-OFF button are not covered by warranty.
We hereby declare under our sole responsibility that this product conforms with the following standards.
IEC 60204-1, EN 55014, EN 50082-2, EN 61000-3-2, EN 61000-3-3 in accordance to the regulations of
directive 98/37/EG and 2004/108/EG.
WEKA Elektrowerkzeuge
7.
R E C Y C L I N G
According to the European regulation 2002/96/EG we have to take back old machines for
departing them by substance and for recycling (see sign on name plate). Please make sure
that the old tool does not get into the unsorted municipal solid waste, but that they are given
back to us, resp. abroad to our distributors.
DECLARATION OF CONFORMITY
12
Publicidad
