Troy-Bilt 12AE76JU011 Manual Del Operador página 10

Unfolding the Handle
1. Remove the star knobs (a) and carriage screws (b) from the
lower handle. See Figure 3-3.
(b)
(b)
(a)
2. Pivot the upper handle into operating position. Be careful
not to crimp cables. See Figure 3-4.
(a)
(b)
3. Reinstall the carriage screws (a) and star knobs (b) removed
in Step 1.
4. Tighten the upper and lower star knobs and carriage
screws to secure the upper handle to the lower handle.
See Figure 3-4.
5. The handle height can be adjusted to any of three
positions. For instructions, refer to Handle Height in the
Maintenance and Adjustments section on page 22 of this
manual.
10 S 2 — A
ection SSembly
(a)
Figure 3-3
(b)
(a)
Figure 3-4
& S -U
et p
Attaching the Shift Lever
1. Remove the screw (a) and the lock nut (b) that secures the
shift lever to the shift lever plate. See Figure 3-5.
Figure 3-5
2. Remove the remaining screw (c) and nut (d) from the lower
shift lever plate. See Figure 3-5.
3. Position the upper shift lever into a vertical position
aligning the holes in the lever with the holes in the shift
plate. See Figure 3-6.
(a)
(a)
(b)
(b)
Figure 3-6
4. Secure the lever to the plate using the two screws (a) and
two nuts (b) removed in Steps 1 and 2. See Figure 3-6 inset.
(c)
(a)
(d)
(b)