Brizo MultiChoice T756 Serie Instrucciones Para La Instalación página 5

Trim Installation
3
B.
3
4
5
Escutcheon Installation
For finished wall thickness up to 1 1/8". Secure
the backplate (1) to the rough-in body (2) using
4 screws (3) provided. Note: Be sure backplate
is oriented front side forward and markings
are visible. Slide escutcheon (4) over diverter
cartridge, thread trim nut (5) provided onto diverter
sleeve.Note: For thick wall installation, order
installation kit RP90545p to support finished
wall thickness up to 2 1/8". On rough or uneven
surfaces it is necessary to apply caulk around the
backplate (1) to supplement the seal. Do not caulk
the drip notch in the bottom of the backplate (1).
Do not caulk the escutcheon (4).
Installation and Adjustment of the Temperature Handle
Failure to do so may cause injury.
D.
2
1
5
Adjust temperature limit stop! Turn on water
supplies; LET THE WATER RUN AT BOTH
FULL HOT AND FULL COLD TO ENSURE
THE WATER IS RUNNING AS HOT/COLD AS
POSSIBLE. Place a thermometer in a plastic
tumbler, and hold the tumbler in the water stream.
Place the temperature handle (1) onto the splines
(2), then rotate the temperature handle until you
achieve your maximum desired temperature
from the outlet (not more than 120° or the lower
1
6
7
75 Series Installation
C.
1
2
3
Volume Handle Installation
Install volume control handle base (1) with lever
pointing down (6 o'clock) as shown. Install the
set screw (2) to tighten the handle base to the
cartridge, then secure the handle blade (3) to
the handle base with the set screw (4).
4
temperature mandated by your local plumbing
code).
Remove the temperature handle and replace
onto the splines (2), making sure that the
temperature handle limit stop (4) hits against the
volume handle limit stop (3) as shown. Secure
temperature handle with set screw (5) using the
allen wrench (6). Insert set screw cover (7)
5
2
4
3
92784 Rev. A