Publicidad
Idiomas disponibles
Idiomas disponibles
Prior to installing Stator/Rotor Assemblies, place the
Selector PCBA into the slotted Housing Support cavity.
Press wires into channel as shown. Carefully place
Stator/Rotor Assemblies into Housing Support, being
sure all components are firmly and squarely seated.
Selector PCBA
Stator
Ground
Terminal
Rotor
Prior to installing the Gear Case Assembly, be sure all
elements of the Electronics Assembly are seated properly
(Stator, Main PCBA, Selector PCBA, On-Off Switch, LED
Assembly and Battery Terminal Block Connector). Be sure the
Grounding Terminal is in place and that all wires are pressed
down into all wire traps and channels. Check to assure that
wires will not interfere with moving parts.
Prior to installing the Housing Cover, place Forward/Reverse
Shuttle onto On-Off Switch and through Housing Support
opening. Check to assure that wires will not be pinched.
Secure the Housing Cover to the Housing Support with seven
M3 x 16mm ST T-10 Screws. Be sure to replace the Housing
Clip at the bottom of the battery opening.
Gear Case Assembly
Model 2553-20
Shown
Main PCBA
LED
Assembly
Forward/Reverse
Shuttle
On-Off Switch
Battery Terminal Block
Connector
Housing Support
Housing Clip to be placed here
Publicidad
