Publicidad
Idiomas disponibles
Idiomas disponibles
3. ELECTRONICS UNIT
3.1. First commissioning
When switching on the electronics unit for the first time, carry out the following programming.
Successive
menus
• Français
• English
• Deutsch
Langues
• Español
ENGLISH
• Italiano
• Nederlander
• Portugués
Date
Month / Day / Year
01/01/01
Time
Hour / Minute
XX:XX
• In line
Display
• Dashboard
In line
3.2. Keypad
COMMAND KEY
(depending on
model)
• Switching on the electronics unit.
→ A few minutes after switching on, production starts automatically.
• Switching off the electronics unit (press and hold).
MENU
→ When switching off, the screen and the green LED turn off while the red LED comes on.
→ If an alarm has been activated, press first on
• Access the menus.
Boost mode starts for 24 hours.
BOOST
• Water temperature display for a few seconds (only if the default display is set to « In line
display »).
T°C
• Direct access to the «
• Salt level display for a few seconds (only if the default display is set to « In line display »).
SALT
• Direct access to the «
Selecting a value or data element.
• Cancellation of an entry
• Back to previous menu.
• Stopping Boost mode.
• Command confirmation.
• Entering a menu.
OK
• Dismissing an alarm.
Possible settings
Parameters - Temp. Adjust
Parameters - Salt Adjust
Navigation
For each parameter, select a data item with the
buttons, then confirm with the OK button.
FUNCTION
to switch off.
» menu (press and hold).
» menu (press and hold).
5
Publicidad
