Publicidad
Idiomas disponibles
Idiomas disponibles
3.7.2. Alarms
• All alarms are activated by default.
• Any alarm that is activated immediately appears on the screen.
• To dismiss an alarm : press the OK or
IMMEDIATE
MESSAGE
AUTOMATIC
DISPLAYED
ACTION
/ FAULT
Stopping
DETECTED
production
Alarm
Cell Current
IMMEDIATE
MESSAGE
AUTOMATIC
DISPLAYED /
ACTION
FAULT
Stopping
DETECTED
production
Alarm
Flow
Alarm
Com. Failure
Alarm
No water
button (short or long press, depending on the alarm).
CAUSE
Yes
Cell problem.
CAUSE
Insufficient water
Yes
flow through the
filtration circuit.
Loss
communication
between
Yes
control
and the power
board
electronics unit.
Insufficient
amount of water
Yes
in the filtration
circuit.
CHECKS AND REMEDIES
• Check that the cell is not scaled.
• Inspect and adjust if necessary the
inversion frequency of the current
supplying the cell («
» menu).
Inversion
• Check that the electrical connections to
the terminals of the cell are sufficiently
tight and not oxidised.
• Check that the cell's power cable is in
good condition.
• Check that the cell's power cable
connector is correctly connected to the
electronics unit.
• As a last resort, replace the cell.
CHECKS AND REMEDIES
Check that :
• the flow sensor is connected to the
electronics unit.
•
the flow sensor is activated
» menu).
Sensors
• the valves on the filtration circuit are open.
• the filtration pump is working correctly.
• the filtration circuit is not blocked.
• there is enough water in the pool.
of
the
board
Contact a professional.
of
the
Check that the filtration pump is running
correctly.
OPTION TO
DEACTIVATE
VIA THE
MENU
«
Parameters -
Alarms
Electrolysis
-
No
OPTION TO
DEACTIVATE
VIA THE
MENU
«
Parameters -
Alarms
(«
Parameters -
No
No
Yes
»
»
14
Publicidad
