Publicidad
Idiomas disponibles
Idiomas disponibles
3.6.4. Calibration of the water temperature measurement
→ If the temperature sensor is disabled, the menu below does not appear.
Menu
Parameters
Temp. Adjust
3.6.5. Calibration of the salt rate measurement
→ If the salt sensor is disabled, the menu below does not appear.
Menu
Parameters
Salt Adjust
3.6.6. Calibration of the pH measurement (option)
Menu
pH Regulation
Adjust
3.6.7. Setting the inversion frequency of the current supplying the cell
I
Current inversion aims to prevent scale deposits on the cell. Current inversion must be set following the table
below in order to ensure that the cell continues to operate correctly in the long term.
Water hardness (°f)
Inversion frequency (h)
Menu
Electrolysis
Inversion
XX h
3.6.8. Selecting the chlorinator operating mode
Menu
Electrolysis
Mode
XXX
→ The choice of operating mode can be seen on the initial display («
3.6.9. Setting the production setpoint
Chlorinator
operating mode
%
Default display
Possible settings
From – 9°F to + 9°F compared to the measurement
displayed, in increments of 1.
Possible settings
From 1500 to 8000 ppm, in increments of 100
Possible settings
From 6.5 to 7.5, in increments of 0.1.
0 to 5
16
Possible settings
From 2 to 24 h, in increments of 1.
Possible settings
Continual production, following the
%
production setpoint.
OFF
Deactivation of the chlorinator cell.
Menu
Specific instructions
Directly select a value using
the
confirmation required).
5 to 12
12 to 20
10
8
Meaning
PROD
• From 10 to 100 %, in
buttons (no
• OFF (depending on the
Default setting
Measurement displayed
Default setting
Measurement displayed
Default setting
Measurement displayed
20 to 40
40 to 60
6
Default setting
Default setting
» as a %).
Possible settings
increments of 1.
operating mode of the
chlorinator).
> 60
4
2
6 h
%
Default setting
100 %
9
Publicidad
