Description Of The Product; Elements Of The Complete Installation - Erreka CICLON CL210 Manual Del Instalador

DESCRIPTION OF THE PRODUCT

1

ELEMENTS OF THE COMPLETE INSTALLATION

TA
INSTALLATION COMPONENTS:
1 Operator
2 LUMI flashing light with antenna
3 Door
4 Exterior photocells
5 Key switch
6 Wall pushbutton
7 Control board
8 Connections box
9 Electrical installation
10 Interior photocells
11 Electrolock (obligatory for CL210/CL250
models in all cases; for other models, only
with leaves over 1.8 m long.)
ELECTRICAL WIRING:
Element
A: Main power supply
B: Flashing light
C: Photocells
D: Key switch
E: Operator
(motor+brake+encoder) *
F: Antenna
* NOTE: the electrical installation of the operator can be carried out correctly and straightforwardly using
the wire with code AYCY8, which ERREKA can supply by metre. This wire has the characteristics
2 2
4x1mm +2x1mm + ((2x0.5mm
Fig. 1 Elements of the complete installation

The safe and correct operation of the
installation is the responsibility of the installer.
Nº wires x section
2
3x1.5mm
2
2x0.5mm
2
2x0.5mm
2
2x0.5mm
2 2
4x1mm +2x1mm + screened sleeve 2x0.5mm
k
Coaxial cable 50 (RG-58/U)
2
)) and was developed specifically for this purpose.
VERY IMPORTANT:
The TC closing stopper and the TA
opening stoppers must be installed in
all cases.
TC
TA
2

For greater safety, Erreka recommends installing the
photocells (4) and (10).
CICLÓN Electromechanical Operator
English
E247A
Max length
30 m
20 m
30 m
25 m
20 m
5 m
39