Attaching Work Clamp; Install Dust Collection Bag; Install Batteries For Laser - Delta ShopMaster S26-261L Manual De Instrucciones

ATTACHING WORK CLAMP

The horizontal work clamp secures the workpiece to the
fence to provide more stability and keeps the workpiece
from creeping toward the saw blade. Depending on the
cutting operation and the size of the workpiece, it may be
preferable to use a C-clamp instead of the work clamp
to secure the workpiece to the miter table prior to making
the cut.
To install the horizontal work clamp, see Figure 6 and do
the following:
1. Place the clamp shaft (A) in either hole (B) on the
miter table base.
2. Rotate the knob (C) on the clamp clockwise to move
it in or counter clockwise to move it out as needed.

INSTALL DUST COLLECTION BAG

The tool includes a dust collection bag that attached over
the exhaust port on the upper blade guard. To install,
slide the plastic collar (D) of the dust bag onto the dust
port (E). See Figure 7.
NOTE: To remove the dust bag for emptying, simply
reverse the above procedure.

INSTALL BATTERIES FOR LASER

1. The battery compartment (F) is located in the control
arm on the rear of the saw. See Figure 8.
2. Using the Phillips end of the supplied blade wrench,
remove the screw (G) securing the compartment
cover and lift off the cover.
3. Install two AAA batteries (supplied) as shown on the
diagram in the compartment.
4. Replace the cover and secure with the screw.
Laser radiation. Avoid direct eye contact
with light source.
ASSEMBLY
B
10
FIGURE 6
D
E
FIGURE 7
F
FIGURE 8
C
A
G