Problem
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
Door does not open easily. You attempted to re-open
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
8.2 Closing the door
1. Clean the door gaskets.
Possible cause
The "FastFreeze function"
is switched on.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been opened
often.
The FastFreeze function is
switched on.
There is no cold air circula‐
tion in the appliance.
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
the door immediately after
closing.
2. If necessary, adjust the door. Refer
3. If necessary, replace the defective
Solution
Switch off "FastFreeze
function" manually, or wait
until the function resets au‐
tomatically to set the tem‐
perature. Refer to "Fast‐
Freeze function".
Set a higher/lower temper‐
ature.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if nec‐
essary.
Refer to "FastFreeze func‐
tion".
Make sure that there is
cold air circulation in the
appliance.
Make sure the door is
closed completely.
Wrap food in suitable
packaging before storing it
in the appliance.
Wait a few seconds be‐
tween closing and re-open‐
ing of the door.
to assembly instructions.
door gaskets. Contact the Authorised
Service Centre.
ENGLISH
13