Maintenance And Diagnosis Of Failures; Maintenance; Failure Diagnosis; Scrap - Erreka ARES AE3324I Manual Del Instalador

MAINTENANCE AND DIAGNOSIS OF FAILURES

1

MAINTENANCE


Before carrying out
operation, disconnect the device from the
power supply.
1 Frequently check the installation in order to discover
any imbalance or sign of deterioration or wear. Do not
use the device if any repair or adjustment is necessary.
2

FAILURE DIAGNOSIS

Problem
The operator does not make
any movement when the
opening or closing controls
are activated
When activating the opening
or closing controls, the
operator is activated but the
gate does not move
The gate moves in an irregular
manner
The gate cannot completely
close (or open)
3

SCRAP


The operator, up until the end of its useful life,
must be dismounted at its location by an
installer who is as well qualified as the person
who completed the assembly, observing the
same precautions and safety measures. In this
manner we will avoid possible accidents and
damage to adjacent facilities.
4

SPARE PARTS


If the operator needs repairing, go to an
authorised assistance centre or manufacturer;
never try to repair it yourself.
any maintenance
Cause
Absence of system power supply
voltage
Electrical installation defective
Control panel or control devices
defective
Gate obstructed or blocked
The operator has been installed
without respecting the installation
levels
G a t e p a r t i a l l y o b s t r u c t e d o r
blocked
The photocell detects an obstacle
The resistance of the gate has
increased when closing (or when
opening)
The force of the operator during
closing (or opening) is too low
The operator has been installed
without respecting the installation
levels
2 Clean and lubricate the articulations of the gate and
the operator supports, so as not to increase the
effort of the operator.
3 Check that the control and safety devices, as well as
their installation, have not suffered any damage
from the weather or external agents.
Solution
Re-establish the power supply
Check that the installation does not
present any short-circuits or cut-off
points
Check these elements, seeing their
respective manuals
Unblock, adjust and lubricate the gate
articulations
C a r r y o u t t h e i n s t a l l a t i o n a g a i n ,
respecting the levels indicated in the
"Assembly positions and levels" on
page 31.
Unblock, adjust and lubricate the gate
articulations
Remove the obstacle and try again
Check the moving parts of the gate and
remove the resistance
Using the control panel programme,
increase the closing or opening force
C a r r y o u t t h e i n s t a l l a t i o n a g a i n ,
respecting the levels indicated in the
"Assembly positions and levels" on
page 31.
}
The operator must be deposited in the appropriate
containers for subsequent recycling, separating and
classifying the different materials in line with their
nature. NEVER deposit it in domestic rubbish or in
landfills which are not controlled, as this will cause
environmental damage.

Use only original spare parts.
ARES electro-mechanical operator
English
35